outdoor fireplace feu ardent logo
Welcome to Feu Ardent's outdoor fireplaces Models of outdoor fireplaces Accessories for outdoor fireplace Assemble an outdoor fireplace Where to buy an outdoor fireplace Contact Les Foyers Feu Ardent inc. Installation du foyer extérieur #100

Assembly advises for outdoor fireplace
Picnic fireplace assembly pictures
Picnic fireplace-plus assembly pictures
Picnic with back fireplace assembly pictures
Picnic with back plus fireplace assembly pictures
Outdoor fireplace #100 assembly pictures
Outdoor fireplace #115 assembly pictures
Outdoor fireplace #120 assembly pictures
Outdoor fireplace #125 assembly pictures
Outdoor fireplace #130-3 assembly pictures
Outdoor fireplace #200-1D assembly pictures
Outdoor fireplace #200-1G assembly pictures
Outdoor fireplace #200-2 assembly pictures
Outdoor fireplace #300-2D assembly pictures

Outdoor fireplace #100

Fireplace #100's assembly

To facilitate the assembly of your outdoor fireplace, refer to the plan received at the
purchase of your fireplace and to the assembly's general section for more advices.


Put the tiles at the level.


Put the 2 blocks Start 34” and the Half-Block 26” between the rear mortises.
Reminder : The flat side of each block goes inside the fireplace


Put the 2 blocks Start 34” so that their back are in line with the base. This way, they will
exceed by the front; it is prettier when installed this way.


Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front. In putting them
down, gently tap the blocks. If there were small stones, that would crush them.
Make sure that your blocks are well placed flat over each other.


Place the 2 blocks of 34” (4 notches) on each side.


Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front.


Place the 2 blocks of 34” (4 notches) on each side.


Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front.


Place the 2 blocks 5 Notches 34” so that their central mortises are off-center toward the back.


Place at the front and at the back a block 42” (4 notches) and 2 little blocks of 12” in the middle.
They will support your accessories.


Place the 2 blocks Arm 4 Notches 34”.


Place the block Chimney 42” (4 off-center notches).


Place 2 little blocks of 12”.


Place the block Chimney 38 5/8”.


Place 2 little blocks of 12”.


Place the block Chimney 35 1/16”.


Place 2 little blocks of 12”.


Place the Top 31 7/16”.
That ends the assembly of your outdoor fireplace!

 
 


Home page  |  Fireplaces  |  Accessories  |  Assembly  |  Retailers  |  Contact us  | Franšais
Site Map

 
   
copyright outdoor fireplace