Fireplace #100
- Assemblages
- Fireplace #100
Put the tiles at the level.
Put the 2 blocks Start 34” and the Half-Block 26” between the rear mortises.
Reminder : The flat side of each block goes inside the fireplace
Put the 2 blocks Start 34” so that their back are in line with the base. This way, they will exceed by the front; it is prettier when installed this way.
Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front. In putting them down, gently tap the blocks. If there were small stones, that would crush them. Make sure that your blocks are well placed flat over each other.
Place the 2 blocks of 34” (4 notches) on each side.
Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front.
Place the 2 blocks of 34” (4 notches) on each side.
Place the 42” (4 notches) at the back and the 2 little blocks of 12” at the front.
Place the 2 blocks 5 Notches 34” so that their central mortises are off-center toward the back.
Place at the front and at the back a block 42” (4 notches) and 2 little blocks of 12” in the middle. They will support your accessories.
Place the 2 blocks Arm 4 Notches 34”.
Place the block Chimney 42” (4 off-center notches).
Place 2 little blocks of 12”.
Place the block Chimney 38 5/8”.
Place 2 little blocks of 12”.
Place the block Chimney 35 1/16”.
Place 2 little blocks of 12”.
Place the Top 31 7/16”.
That ends the assembly of your outdoor fireplace!